The official Honda Thread

I would recommend the shorter belt. I tried running the longer one at it would rub together at higher RPM's. 

 
Last edited by a moderator:
any suggestions for a honda j35 turbo dyno tuner in the LA area? 

fwiw - its a low output build....pump gas, approx 8 psi boost

thx

 
basketcase said:
I havent looked at the center hole to see if it misses that large one that I have, but what did u do with that?  Also, which belt did you use.  Looks like there is one that is 42-7/8" (K060423) and 42-3/4" (6PK1065).  Only 1/8" of inch, but still feeling I might just do the shorter one as is.
Click to expand...
I plugged the larger hole with an aluminum rod, but I don't think its necessary.  I don't remember off hand which belt I have but I would go with the shorter one. 

 
Manxaru said:
any suggestions for a honda j35 turbo dyno tuner in the LA area? 

fwiw - its a low output build....pump gas, approx 8 psi boost

thx
Click to expand...


Manxaru said:
AEM series 2 plug and play
Click to expand...
I'm running the same ECU at 10psi with pump gas.  Been running it for two seasons.  I have an intercooler on mine and if I wasn't building another engine for more boost I probably wouldn't spend the money on a tune unless I was seeing/feeling/hearing start to knock some.  But there is room to squeeze more HP out of that setup.  I was going to try and get ahold of Dunehoon for my tuning, but if I can't get time there I'd go with the tuners suggested above.

 
LtPyro said:
I'm running the same ECU at 10psi with pump gas.  Been running it for two seasons.  I have an intercooler on mine and if I wasn't building another engine for more boost I probably wouldn't spend the money on a tune unless I was seeing/feeling/hearing start to knock some.  But there is room to squeeze more HP out of that setup.  I was going to try and get ahold of Dunehoon for my tuning, but if I can't get time there I'd go with the tuners suggested above.
Click to expand...
Which motor do you have? J35a1? and is you motor stock? or did you put in lower compression, forged pistons and rods, etc?

 
Luckily i have an j35 a1 and it uses a simple tensioner that does not have the shock absorber thingy.As for belt i use the one posted last 3 numbers 623.

 
You must log in or register to reply here.
Back
Top