- Thread starter
- #101
ranman5608
Active member
- Jan 23, 2023
- 134
- 184
Got the frame back from powder. Powder Coating AZ did a killer job.
Offloaded this thing and got right to work first thing was to tackle the 120 Dzus springs and damn am i glad that's over. I do not like when people coat the springs with the frames so I will always pull the springs and replace them with new ones but since I did this all last season they were all still good just had 200 rivets to remove from the springs what a pain.
Then I installed the gearbox, fuel tank, peddle assembly, radiator, and turning brake so i can make a couple new brake lines since I went with a new turning brake this time the empi ones have the ports coming out of the side and they were a little too close to the seat the ports on the jamar come out of the back so that fixes that issue. With that I have a brand new empi turning brake for sale shoot me a message. I then mocked up the seat just to make sure everything clears as it should and were good. on to the next task
Offloaded this thing and got right to work first thing was to tackle the 120 Dzus springs and damn am i glad that's over. I do not like when people coat the springs with the frames so I will always pull the springs and replace them with new ones but since I did this all last season they were all still good just had 200 rivets to remove from the springs what a pain.
Then I installed the gearbox, fuel tank, peddle assembly, radiator, and turning brake so i can make a couple new brake lines since I went with a new turning brake this time the empi ones have the ports coming out of the side and they were a little too close to the seat the ports on the jamar come out of the back so that fixes that issue. With that I have a brand new empi turning brake for sale shoot me a message. I then mocked up the seat just to make sure everything clears as it should and were good. on to the next task
Last edited by a moderator:
