Search results

Compound turbos can be incredible to make instant low end boost. And are more efficient in that they can broaden the power curve. Basically n the application I’m thinking is a GTR v6. There would be the basic two turbos hanging off the exhaust manifolds. The tail pipes of these two turbos...

Well over the past few weekends I’ve been super busy. Took the bucket and quick change rams off of my excavator to rebuild them. Huge job. The ram I guess is 600lbd. The quick change is probably 1000lbs. Had the shaft hard chromed. Nut was on with 3200 ft lbs. my custom wrench cost me $375 to...

I will but curious if anyone has done one in the dunes and what was the result?

just curious if anyone has seen one or know of any successful reports of someone running one. I am usually a "KISS" kind of guy but i do have some interest in a custom project

that is cool, way to go Ed and Ramone!!

You do have adjusting nuts at the shifter for right and left. However before you do that the shifter handle must be perpendicular to the shifter box while in neutral. You may have to lengthen or shorten the overall length of shaft by disconnecting the joint at back and give a few full turns. If...

Worked on the mini x pinion drive had a hydraulic leak for a long time. Installed it and tested it on my new lot. Pulling out a few huge rocks knocking down an old dead tree. Got a 35’ fiberglass flagpole delivered ( for the new lot) went to my buddies surprise 60th birthday party This week I...

Love rotties. About time I get another one. Love the pool pic

Early 90’s was invited by a friend and took my IT200. Seized it in 1 hour going full blast everywhere. Saw olds and everyone had CR500’s and fast. Had no money so I bought a CR480. Thought I would kick everybody’s butt. I was still the slowest. That bike was a monster. Arm pump in 10 mins...

Took the quick hitch off my 50k lb excavator to rebuild the ram. Took 4 hours just to get it off and 4 hours to disassemble. Had a stuck pin that took relieving with a drill, pb blaster and 20 ton press at full bypass and heat and it still wasn’t budging until I hit it with an air chisel and...

injectors on race fuel are probably fine i would start it up first the pre filter that we use is a 1/2" push on nipple both sides 100 micron $15

great end to the story again if he's leaving it in storage...leaving lots of lug nuts off is a great deterrent

Congrats. What kind of fuel? You should change fuel filters once a year at a minimum. Plug type is importsnt snd max gap at .025”

Honey do’s are always first on Saturday so just put the sliding organizers in the pantry. Just got 6 done and my wife has just informed me she ordered 8 more!

The word "queue" is ironic. It's just a Q with a bunch of silent letters waiting in line.

cool!

i forwarded the info thanks

We had to raise the rpm with 6 cylinder too

the new one? i have never seen it. its in Vegas

their previous car was a subaru with a small blower(i didnt set it up) they wanted it to be turbo and there was just too much cost involved to convert to turbo so he bought a different car and did not know i dont do hondas--thats how it got here