EastMT
Well-known member
- Jul 21, 2022
- 970
- 624
Is there an agreed upon new clutch break in procedure? New single disk, 2D , Honda 3.5. Got the Slave cylinder adjusted and shifting great. How many miles, what rpm or vary rpm, low load???
New clutch break in
- Thread starter EastMT
- Start date
Jammer75
Well-known member
- May 5, 2021
- 547
- 502
Grip it and rip it. When will you be at st. Anthony?
- Thread starter
- #3
EastMT
Well-known member
- Jul 21, 2022
- 970
- 624
The 21st to 26th of this month.
lincster
Well-known member
- May 5, 2021
- 828
- 638
I sure wouldn't put it on the dyno with a new clutch. 
Just normal driving around for a bit and that is all that is needed.
Just normal driving around for a bit and that is all that is needed.
Rockwood
Well-known member
- May 5, 2021
- 5,951
- 7,638
Yep. Assuming you cleaned all the manufacturing/anti-rust schmoo off of everything before installing.I sure wouldn't put it on the dyno with a new clutch.
Just normal driving around for a bit and that is all that is needed.
Sandkist
Well-known member
- May 6, 2021
- 2,913
- 679
Dodd
Active member
- May 8, 2021
- 166
- 156
Just had mine rebuilt at McCleod. They said absolutely drive it lightly to medium through a couple heat cycles. We’ll see how that goes.
J Alper
Site Sponsor
- Apr 30, 2021
- 2,015
- 1,749
These are not fragile clutches built for the street with ceramics in them, you have a fiber clutch with copper, same as a top fuel clutch,
There is ZERO break in on a 9'' and 8'' 6 puck clutch,
You are good to go,
There is ZERO break in on a 9'' and 8'' 6 puck clutch,
You are good to go,
- Thread starter
- #10
EastMT
Well-known member
- Jul 21, 2022
- 970
- 624
Thanks for all the answers. Hopefully everything goes well on my St Anthony trip.
