Stopped by R3 fabrication! (Shop Tour)

RiverDave

RiverDave

Administrator
Staff member
Joined
Aug 7, 2024
Messages
1,010
Reaction score
1,271

So last week I had an opportunity to meet up with Chris Redden from R3 fabrication to check out what’s going on at his shop. The videos will be ready in the next few days but here’s the pics!

Out front he had a racer engineering car that is currently being prepped for the 400!

IMG_8862.jpegIMG_8863.jpegIMG_8864.jpeg
 
Last edited:
Inside he had his personal R1 that is getting prepped for the next race as well!

IMG_8865.jpeg
 
  • Like
Reactions: GBR
In the back was a center steer buckshot that he is rebuilding for a customer.

IMG_8873.jpegIMG_8874.jpegIMG_8875.jpegIMG_8876.jpeg
 
Chris has been around in this industry for quite some time for those that don't know him. He certainly does quality work.
 
IMG_8877.jpegIMG_8878.jpeg
Outside there was a pretty bad ass ford ranger pre runner and I got a kick out of the light setup on the motorhome.

There was also an all wheel drive trophy truck there but it was under a tarp so there wasn’t much point in taking pics of it.
 
You must log in or register to reply here.
Back
Top