Chevy LS PCV question

[chopshop]

What are people doing .
Chevy LS n/a are people running the stock PCV set up or have you gone with an open system with a catch can ? -10 AN on each valve cover

Thanks

 

[wesinls]

Catch can for me.

 

[lincster]

When my motor was NA, I just used the stock system, but the motor was 100% stock.
If a NA motor is built, I would vent it to a catch can.

 

[rivermobster]

Doesn't everyone (LS) use a catch can?

Summit Racing has some good products.

 

[FENDERFAB]

Mine is setup with a can.

Used this on the oil fill cap- Replaces the cap so you can vent it to your catch can. Simply untwist it to add/refill oil.

LS Billet Vented Oil Cap to -12ORB Male Fitting by Motion Raceworks

LS Oil Cap to -12ORB Male Fitting by Motion Raceworks 34-00045 Easily add a PCV connection to your factory LS valve covers with this billet oil cap with machined in baffling. This screws directly into LS factory valve covers and has a -12ORB female thread. This means you can adapt up and down to...

motionraceworks.com

This is for the opposite side with no fill.

10AN Push in Fitting for Factory GM LS Valve cover grommet

10AN Push in Fitting for Factory GM LS Valve cover grommet Motion Raceworks This billet aluminum fitting presses into the driver side rear valve cover grommet on Gen 3 and 4 LS engines to adapt to 10AN for easy connection of PCV systems. Made in the USA Includes grommet for use if not using in...

motionraceworks.com

and there are a variety of catch cans available. Motion raceworks has nice ones.

 

[Jtmoney714]

I dump it to the ground.

 

[Rockwood]

If stock displacement, run it stock.

If not, both valve covers and the valley cover should be vented to a can.

 

[Funco4JM]

I removed my stock PCV and ran it to a Motion Raceworks dual 10AN can. One from each valve cover.

 

[Looney Duner]

I ran 2 hoses to the bottom of the chassis, simple.

I don't care if the engine is stock or not, I don't ever want hot oil fumes going into the engine.