Boat wiring cost

[Kraut_n_Rice]

Obviously the is a broad spectrum topic...

But...what would a general cost be 20'ish foot V-drive boat. It will be FI on Holley, but that wouldn't be handling that part specifically, tapping into it to make it work only. Every other function of the boat would be otherwise. Bilge, blower, transfer pump, lights, hatch, and cav plate pedal..

It's simple. 7+1 switches on the dash/foot. No radio.

No materials, just labor. What do ya think? Figure some of you guys might have some experience

@RiverDave @rivermobster

 

[Mac]

Do not use Gorr performance or whatever else he calls himself these days here in Havasu. Dude is a has been crook.

 

[Grease Monkey]

Sounds like a 40 HR job to me.

 

[rivermobster]

Sounds like a 40 HR job to me.

I'm confused about the EFI part...

@Kraut_n_Rice ...

You should make a list of Exactly what you want done. And add a few pics. I could give you a pretty accurate estimate that way.

 

[Kraut_n_Rice]

I'm confused about the EFI part...

@Kraut_n_Rice ...

You should make a list of Exactly what you want done. And add a few pics. I could give you a pretty accurate estimate that way.

It's not my boat. I'm just doing the work. I'll be wiring everything but the engine. Another guy is handling all the engine loom.

 

[RiverDave]

Do not use Gorr performance or whatever else he calls himself these days here in Havasu. Dude is a has been crook.

Pretty sure he got cancer?

Steve Panter the gel guy that was in there unfortunately left a lot of people hanging.. six I really like the guy and his talents are unreal but not good a biz.

 

[RiverDave]

It's not my boat. I'm just doing the work. I'll be wiring everything but the engine. Another guy is handling all the engine loom.

So you don’t have to do gauges or anything? Just the dash switches?

I’d trim / trailer considered motor or you?

 

[dbart]

About a thousand dollars......

LOL

 

[rivermobster]

It's not my boat. I'm just doing the work. I'll be wiring everything but the engine. Another guy is handling all the engine loom.

You honestly not giving me much to go on here...

Just charge 100 bucks and hour and call it good.

That would be using non insulated, pre tinned connectors, marine heat shrink, and pre tinned wire.

Make sure you account for your water proof fuses and relays as well.



If it was me...

I wouldn't want to be involved in a Partial wiring job. Stevie Wonder can see the finger pointing that's gonna happen here, from a mile away.

Ugh.

 

[Kraut_n_Rice]

No gauges. Has a Holley display.