Art Morrison history

[onanysunday]

Pretty cool. https://fuelcurve.com/art-morrison-enterprises/

 

[BONES]

Cool article. They make an awesome product. Thanks for sharing 

 

[Bobalos]

That was super cool. 

 

[Kat-A-Tonic]

What do those bolt in frames run?

 

[onanysunday]

What do those bolt in frames run?

$17-$20k for a non independent setup with 9" rear.

 

[onanysunday]

 

[J Alper]

did you see the welding table, holly crap it was sturdy 

 

[onanysunday]

Very likely I will be ordering one of these frames within the next 6 months. This one was for a 66 Chevy Van. Lots of measuring and figuring first.  Width of an LS based motor online is 26" and not sure if 29" will be enough. Need to measure a motor in the shop. I also have some other questions I have sent to Chris at Art Morrison.

 

[onanysunday]

Quite the process just to measure before ordering.

 

[onanysunday]

He has 15" wheels in the drawing but I want 18" wheels.  Tires front will be Proxes 888r 315/30 R18 back and 255/35 R18 fronts. Then some TSW bathhurst wheels. Can't wait to start measuring and make it all fit. 

 

[Kraut_n_Rice]

did you see the welding table, holly crap it was sturdy 

One of our fab tables is about 3" thick cast iron ground flat with a C channel base.  HEAVY SOB...

 

[onanysunday]

@dbart  Are you able to photoshop those wheels under the truck? It will be lowered way down so they will be tucked up underneath. 

 

[onanysunday]

This is a Ford but I am wanting the stance about like this. Down low but not so far in the weeds you rub every curb. This thing should rail around corners.

 

[Kraut_n_Rice]

My grandpa had an early 60s Econoline van behind their house when I was a kid.  Wonder where it went..

 

[onanysunday]

My brother is going to photoshop it tomorrow.