Search results

So what are all of the starch users using now??

My last trip on the very last run at St. Anthony's my car just died about halfway thru the dunes.  Waited a couple of minutes and it fired back up.  Decided to head back to IDRV, and make it about 5 minutes or so, and it cuts out again.  Rinse and repeat 3 more times and finally back at IDRV. ...

I want to make sure that I am measuring from the correct points.  I assume that for D1 it would be from the lower shock bolt straight across to the lower rear Heim.  What I am not sure about is where the outer spindle pivot point is or D2. Does anyone know for sure what they are referring to...

Can any one tell me who the manufacturer and model # of this fuel cell please????

Which Throw out Bearing.  I remember my Trans guy showed me on my old trans.  that it could be taken apart, cleaned, and re greased. I sold it though with the 4e. Which of the 3 below?  1, 2, or 3???? INA Clutch Throw Out Bearing For Beetle Or Bus IRS 1971 And Later Or Mendeola 2D or MD5...

I have my Bookmarks to open the site to View New Post, and normally it would show all of the newest posts.  Now it is showing this:

Does anyone actually bother with getting this for glamis?  Do they actually enforce it?

What is everyone using to protect the charge wire from the Alt. to the Starter?  Fuse, Fusible link?  What size wire, and Alt. Rating? Thanks in advance.

Does anyone know what time the Aragon MotoGp race is on tomorrow?  According to the list CNBC is supposed to be showing it 1:30 ET, so 10:30 Pacific, but the guide doesn't list it at all. 

@John@Outfront John, is there a different bracket that supports the alt. when not using a power steering pump?

@John@Outfront  John, which switch/sensor due you recommend for a 2.5 DOHC Subaru idiot light?

Show me your brightest, most original BAD ASS camp locator lights, lasers, strobes etc....

Hey John, I believe one of your staff gave me the incorrect torque spec for the valve cover bolts.  They have 6 in lbs. Can you give me the correct torque please.

John, I know you covered this before the site crash, but can the return be any of the 3 possible AN fittings?

What is the Torque on a  8" Stage 3 KEP pressure plate and the flywheel bolts?  Any loctite required?  Motor is a 2.5 Subi and trans MD4E.

Where are you purchasing Bel Ray Molylube Anti-Seize CV Joint Grease Compound 15oz Caulking Tube?  Kartek is OUT OF STOCK.

Which pump do you recommend for the Transaxles? Tilton Engineering 40-527, 524, or 525?