Search results

303 Aerospace Protectant got greedy and wanted $60.00 for a gallon, so switched to: VRP $37.44 for a gallon, and I dillute it with distilled water in a spray bottle like suggested by a user that is a Pro. Detailer.

LTS is Rebranded Hikvision and they write their own Firmware for Cameras and NVRs.  (Same brand I use) I have installed a couple of these. Platinum Enterprise Level 64 Channel NVR 2U LTN8964-R  Ran more than 10,000' of Cat 5, and installed 58 4MP cameras for the most recent one.

Happy B-Day!!!!! 

Using the needle again I pack the CV in the hub with Swepco and put a layer of BelRay on top of that. All bolted up. I get the boots on and tighten them down and the CV's and axles are done.

@L.R.S. This was posted by LRS Pre Crash.  It had a much better format, and I am sure that I am missing a few things (I abbreviate to save page space) Same here but I use Swepco Moly 101 to pack the CV's and then a layer of BelRay Anti Seize over that on each side of the CV. I also fill the...

To troubleshoot the fan being constantly on, if the ecm is powered up, and no signal to E. Temp pin (this will eliminate the possibility of the engine temp sensor being bad) then under normal operation there should be no continuity between Fan Pin and Sig Gnd correct John? Or 0 volts reading...

Do you have any contact cleaner?  Can you clean the 9 solder joints thoroughly to see if there are any voids similar to what I posted?

This is from a Link ECM, note the circled pins.  This car was @John@Outfront Shop a couple of weeks ago, and had very similar symptoms.

I ordered this one.Oil Pressure Sending Unit - Subaru (25240KA041)

I think it is to the right of the Oil Pressure Sending unit.  The car is in the trailer, and I have to climb up and over to get any access to it.  That is the Idiot Light sender correct?  When I was looking online, there were several that looked similar.  I was hoping to get the sender, before I...

These are the senders that are in the car.  Yes I am running a light, and a pressure gauge, and a Oil Temp gauge. 

These are the 2 on the 2.2, I can not get to the other motor until later.  I know one is for oil pressure gauge, the other for the light.  Are either of these the OEM unit?

@John@Outfront  John, which switch/sensor due you recommend for a 2.5 DOHC Subaru idiot light?

That might be a little heavy for the top of my pole.

12V Green Diode Lasers 532nm Laser Module Dot I was thinking something like this on top of my 40' pole.

That is exactly what I want. 

Show me your brightest, most original BAD ASS camp locator lights, lasers, strobes etc....

Hey John, I believe one of your staff gave me the incorrect torque spec for the valve cover bolts.  They have 6 in lbs. Can you give me the correct torque please.

John, I know you covered this before the site crash, but can the return be any of the 3 possible AN fittings?

I was there at the same time.  I can see my trailer in the vid.