Old Funco Gen 4 934 mid board hubs

A

AlpineFunco

Well-known member
Joined
May 5, 2021
Messages
774
Reaction score
960
I picked up some 934 hubs. They were disassembled, cleaned, and put into a box. I've got a question about assembly. Can someone confirm that the spacer goes on top of the rotor hat as pictured in pic # 2 and NOT between the bearing and the hat as in Pic # 1. And also, the flange in pic # 3 is used on the trans side cv's, correct? And does anybody have a part number for the seal that I need for this?

Thanks


IMG_8714.jpegIMG_8715.jpegIMG_8716.jpeg
 
turn pic number 1 over and take a pic there needs to be a special flange there with threaded holes
i dont see your six long bolts to assemble
the main seals are timken 417556 and will be at least $100 each
the inner lip seal you might not know you need is VL170
turn the hat over and take a pic of the inside
yes the flat steel spacer goes on the outside of the aluminum hat
 
John@Outfront said:
turn pic number 1 over and take a pic there needs to be a special flange there with threaded holes
i dont see your six long bolts to assemble
the main seals are timken 417556 and will be at least $100 each
the inner lip seal you might not know you need is VL170
turn the hat over and take a pic of the inside
yes the flat steel spacer goes on the outside of the aluminum hat
Click to expand...
image.jpg

I have the bolts, just used two to hold it together.
 
You must log in or register to reply here.
Back
Top