Loganhawkins418's latest activity
-
Gray Area makes really nice stuff, just checked his price on those and at that price point his 2" front is hard to beat. If you call and... -
My group is getting there on the 17th. 3 of them are leaving on the 21. 3 of us are staying until the 23rd. Not sure where we r going...
-
Loganhawkins418 replied to the thread Upcoming trip.Might have to give a guy I know a call! 🙃
-
Better Know Someone!!!
-
We’re heading out Wednesday the 19th and was wondering if any of you guys that might be out there camped on one of the pads might be...
-
Loganhawkins418 replied to the thread Dyno tune.PM’d you his number. Sorry to take so long.
-
Loganhawkins418 replied to the thread Dyno tune.If you’re in Glamis for the month reach out to Steve Cole and see if he can clean up the tune for you, I believe he’s out there all...
-
Did you guys watch the video....this is no different than the lawyers who sue businesses for no handicap access. IT'S A FUCKING SCAM...
-
Loganhawkins418 replied to the thread Wiring questions.I wired my intercooler fans with two separate relays that are triggered by the fuel pump output on my Holley system (it also triggers...
-
Loganhawkins418 replied to the thread J35 build.There’s a great Facebook group for e85 in Arizona, all the street car guys use it and post their test results, it’s not as hard to find...
-
Loganhawkins418 replied to the thread 934 CV'S.Curious why turned down cv body’s won’t work? There isn’t that much taken off, they work fine on the transaxle side and microstubs when...
-
Loganhawkins418 replied to the thread J35 build.Roughly 8k, around 5k in parts for motor build.
-
Nice build. Bore supports need additional machining, or press them in and no bore distortion? Corn or race?
-
very nice!
-
Loganhawkins418 replied to the thread J35 build.They require the cylinders to not be out of round so on a used block you may need a hone or bore. These had no variance in taper or out...
