Recent content by jmp

I use the clutch in my s4. Especially when down shifting. Common sense tells me that taking the load off the gears is better for all the components in the transmission.

Looks like a fun car. What size whipple Are you running on it?

The deck overs I have looked at ar 14k gvwr.

I have been shopping for a trailer for about a month. We have been going back and forth between a power tilt deck over or an enclosed, both 24’. I have learned the CHP are beginning to enforce trailers gvwr over 10k and require a class A cdl. What has your guy’s experience been with this? I...

I have 383” ls1 in my Tatum black widow that I am interested in adding a pair of turbos to. I would be happy with 600hp to the wheels. Does anyone have a Ls tt setup they would be willing to to sell or know of a place to go to start gathering parts?

Does anyone have recommendations for a transport service that can deliver a 24’ enclosed trailer from Missouri to So Cal? I am looking to purchase a new trailer from a dealership in Missouri and trying to figure out the logistics.

Thanks for the reply, but I was actually able to buy a new body from the manufacturer.

I was able to get a complete fiberglass body for my old Tatum black widow that had a flat windshield, aluminum side panels/ roof and an open front. I need to get a windshield for the new curved glass frame that was included with the fiberglass body and am hoping someone knows which one to get...

Hello all, I am new to both the Glamis Dunes Forum and to sand cars. I recently purchased an early (2002) black widow and would like to add a firewall and hood. I assume that the frames are the same. Does anyone know where to source the fiberglass body panels that came on the later cars? I am...

For the price fusion is hard to beat. I believe there are a few Haas posts for cam that may work for your machine.

the sheet metal function is more for sheet metal fabrication,ie. bending flanges etc..

Your issue most likely is that you need to save it as a dxf file. This is assuming the part is going to be laser cut. I would re-draw the part as a sketch and then save as a dxf and send to them that way.