J Alper's latest activity
-
J Alper reacted to EastMT's post in the thread It's Saturday Sept 6th 2025.. What is everyone doing this weekend? with
Like.
Bleeding brakes and clutch on sandcar. Bought a power bleeder and don’t think I could go back to manual bleeding on the sandcar again... -
J Alper replied to the thread Tatum billet spindles / uprights.That is a lot of spindle for the money,
-
For a new build and minor cost increase, I would say yes. In my case, a retro fit, I would have had to REALLY cut my car up to get it to...
-
J Alper replied to the thread Sandblast DVD - Clutch Films.I think i have one, I have a bunch of DVD, is it hard to turn them in to Digi
-
J Alper replied to the thread S5D vs Fortin FRS5.Correct, Lincster thank you for the support. I wish the S4D had a bigger Diff than the S4, only having just the ring and pinion bigger...
-
J Alper replied to the thread S5D vs Fortin FRS5.Will snap a picture have both trans in the shop the Ring and pinion area is much taller on the S4D, than the S4, the gear stack area is...
-
J Alper replied to the thread S5D vs Fortin FRS5.The other part to consider, just going from a S4 to a S4D the trans is much bigger in height I had to move the trans/CV area up...
-
J Alper replied to the thread H pattern dog box.The issue is that the dogs can round the edges, when this happens, it does not hold a gear, I have missed a shift (grind it till you...
-
J Alper reacted to onanysunday's post in the thread Country Coach intrigue 32 ft (((((Solar install))))) with Like.
I really like how this guy mounted his panels on the roof using strut channel. A little more work and adds a little more weight but I...
-
J Alper replied to the thread Trick to removing bearings?.This is the VW Style setup, Really sketchy setup, I like to bore out the hole and weld on the Cheaper Empi Mico Stub kit, then you...
-
J Alper replied to the thread S4 first gen indictor?.For anyone doing this, From the PM's i got, you need to start from the basics, Get this working with a Hand Held Volt Meter before...
-
J Alper replied to the thread S4 first gen indictor?.Next check you output on the trans Mine was around 1v for first, so this is my cal chart, make it a variable voltage so the screen...
-
-
J Alper replied to the thread S4 first gen indictor?.Next use the dropdown and pick Custon 5V Use the CUSTOM 5 VOLT AT THE VERY BOTTOM OF THE TAB show below right below 5v
-
-
J Alper replied to the thread S4 first gen indictor?.You will see the Input Tab, call it Shifter, then Type is 5V, Enable needs to be clicked, After this you can click the Configure page...
