I bought a Gen 4 funco that had fully built closed deck turbo Honda that was sold to me at 500 to the tire. It had a Fortin 4 speed sequential. It originally had a 2d. When I asked the original owner if the swap was worth it he said yes. I broke the 2d every weekend and I have 8 seasons on this...
We run top in lube in our E85 already so it wasn’t a change for us. We run it for the smell. I like the grape drink smell. A friend of mine runs a weed smell one. I am sure there are benefits to running top in lube but we run it only for smell purposes. We didn’t change anything with the...
I had a whole weekend with the speed key. I first topped the car off with E85 after a short ride. The sensor was reading about 25% ethanol. Just using the speed appeared to add about 25% responsiveness down low. After a couple more top offs I am sitting at about 70%. At 70% this car is a...
That was me. So far I am really impressed. Just crossed the 500 mile mark and the speed key got shipped to my house in Arizona so I should have some feedback on the 300hp tune.
Haha, that’s a fairly bold statement. I have never run a clutch cover on a side by side and never had one go out in a couple of trips. My last rzr lasted 4 seasons. I will give you some feedback after new years. Keep in mind I am in Glamis a lot and I will probably go through 300 gallons of fuel...
I finally have a Glamis review. I drove the speed all last weekend and it was flawless. I am about to hit 500 miles and I haven’t had one issue. I haven’t even broke a belt. It’s probably because I bought the white glove warranty. I did take the windshield out and the car has only gotten up to...
We have had both in funcos over the last 7 years. I will say I have never driven a turbo motor on 91 so I can’t tell you how they perform. A blower motor on pump gas will be slow. Anyone who says something else has never drive something actually fast. A blower motor at 14-15 psi on good fuel is...
Freshly rebuilt by Aeromotive with zero time on it. We purchased it as a spare from 928X but ended up going a different direction. Rebuilt because of fuel starvation due to being improperly plumbed. $1100. Located in Phoenix but I can bring it to San Diego. This is big HP/E85 stuff. You can use...
I got mine on Saturday. I went through the whole car. I found 6 hand tight roof bolts and one breather hose not connected. I have been almost killed because of bad prep and so I go through every car we get the same way. I felt the final assembly did a great job. With the exception of what I...
I have the 2d out of my Gen 4 for service and I brought home a S4 mock up from McMullen out here in Phoenix. This Gen 4 is an original V8 2d 930 car and I wanted to see if the S would fit. Here is a photo of why it doesn’t fit basically the back tube would have to be cut out of the car. I am not...