DarkSide's latest activity
-
DarkSide replied to the thread Is theft an issue camping during the week.I had my buggy stolen back in 1999. Thieves stripped it and dumped it a few washes down from where I was camped. Since then, I have... -
DarkSide reacted to Meter Tech's post in the thread Is theft an issue camping during the week with
Like.
I prefer to make it difficult to steal any of my shiat....I lock up the portable Generator and the Rail...lock my exterior storage... -
Hey gents, The car is complete! This is my first successful radius windshield cut and this is a tricky job so shout out to all the...
-
DarkSide replied to the thread Holley ECU.Oil cooler is on my priority list for the off season. I always had an oil temp gauge on my VW engines since that was the only fluid to...
-
My engine oil temp sending unit was $40 autometer unit. Programmed the TermX with the correct table and works great. Engine runs 200...
-
Biggest no no to a LS engine is no Oil Temp, you I have had water temp at 140 and at the same time oil was 320, really should have a oil...
-
DarkSide replied to the thread Looking for used STU RazorBacks 10.50-17.I have an older pair still in good condition and hold air. Located in Lake Elsinore.
-
https://www.prowireusa.com/txl-wire
-
I just finished installing a Terminator X. I used a simple weatherproof box and cut a window in it and installed a piece of plexiglass...
-
I have two of the Holley harnesses - one on the sand car and another on a street truck - both working fine. Someday I want to buy these...
-
I went terminator and put it inside of a "sealed" outdoor electrical box that I got for $10 at home depot. Then put it inside of my rear...
-
Scroll toward the bottom of the page. Side by side comparison of all 4...
-
I went with the HP. It is sealed and if im not mistaken it is also potted. I figured with the vibration and the exposure to the elements...
-
I bought my Term X with the Holley harness. Alex Arvizu did the wiring. He didn't mention having to modify anything in the harness...
-
DarkSide replied to the thread Holley ECU.My current harness is a mess. I do have good fuses/relays for fans and fuel pump so I should have no issues tying those in.
