Search results

So I found the problem with the centerforce clutch and just finished installing the fix. Need to get my throw out bearing closer. Going to change the slave cylinder piston for one that is a little longer. Might have to lathe it down a little bit but otherwise am in good shape. -Landon

Copy that! I’ll call Ron tomorrow, thanks for your help Sean. I’ll report back his findings and solutions for me

*Status update* Got the clutch apart and everything looks great! The splines on the clutch disk slide freely with the input shaft. All good The only thing I noticed is the amount of sand/clutch material that is jammed in between the casing of the pressure plate and the back of the plate it...

Thanks for the reply Sean, Everything you said makes complete sense I did check the release point as instructed in the manual. It just seemed that it would get worse so I would move the stopper a little and it would alleviate the issue but only for a short term. It is also difficult to get...

Thanks for the reply Jason, Did you ever figure out what the cause was on the centerforce? It’s hard to believe that it’s common it’s a nice unit. So kennedy makes the flywheel they just don’t keep one on the shelf?

Hello GD, I have a S4D on a twin turbo 440 LS motor the makes 1100 wheel. I am currently using the weddle/centerforce racing double 11 clutch. When I first switched to the Chevy bellhousing and this clutch a couple years ago I setup the pedal stop for the internal slave as directed by the...

Who was flying the drone around you doing wheelies on China wall on Saturday after the ceremony? I was the guy in the grey 2 seat car also tearing up the hill and would like to see the video. LOL

:party3:

 thank you!! 

Anybody know of someone in the IE that does the 3m clear wrap? I just got some chrome bypasses on my car that I would like it to protect.    thanks for any help you guys give. 

I went in June also! But i’m still dealing with the consequences 😂 

Working on getting the trans outa my car to get this mess fixed and ready for next season. Idaho dunes done my car in real good this time 🤣 

I am on a twin turbo 440ci. Running a shearer fab intercooler on a Holley lo ram. The Heat exchanger is a cbr 35x10 dual pass mounted directly in front of my radiator with variable speed fans so they are always pulling air through the intercooler. Meziere 20 gallon water pump. No problem with...

Who do you guys use to rebuild turbos preferably close to Riverside. Or do I need to send it in? Have a couple of ball bearing precisions.  One of them stops sooner and makes noise when spinning down. No slop in shaft just noise and little resistance. Probably needs new bearing cartridge ...

Holley pro dash in center, switch pros and pci setup next to and under the steering wheel. Big glove box over on the passenger 

Know anybody that makes custom harnesses for sandrails or race cars in general. Have some extras that I need for boost control, extra sensor plugs. etc.. want it real nice  thanks guys 

Thanks guys!! 

That’s my setup. Holley lo ram with a shearer 1800hp intercooler. Works great! 

The hp is controlling the speed of both from one pwm- output. You give the fans power all the time and let the pwm signal start, stop and control them. There is no external control it is all integrated in the fan.    the reason I went with the variable speed fans it because I don’t want to...

Happy birthday bud !