SeanRitchie's latest activity
-
SSeanRitchie replied to the thread Sequential shifter - does it need the limit stops?.The PBS and early Mendeola Gen 1 shift mechanisms DO NOT have any internal stops. It would be recommended to use a shifter with stops...
-
SSeanRitchie replied to the thread Internal CV joints.He has been making them for his front diffs for a few years. Problem is that there is no "differential" anymore, and they don't turn for...
-
SSeanRitchie replied to the thread S4 breather.So, That vent location never changed from Gen 2 to Gen 3. It might have been different on the super early Gen 1 housings that said...
-
SSeanRitchie replied to the thread s4 upgrades.
-
SSeanRitchie replied to the thread WTF? Tornado?.Got woken up by all of the emergency alerts at 1:30 AM when I was still in Ventura a few years back with tornado alerts. I've never seen...
-
SSeanRitchie replied to the thread The Transaxle Thread.A bit of confusion in your questions: 1. A "3-Rib" is a 1969-1971 002 bus trans. This has the same size gears as a Type 1 Beetle trans...
-
SSeanRitchie replied to the thread PBS Is Done.Closed up in 2020. Transmission and windmill gearbox sales tanked. At least you can convert a PBS S4/S5 to a Weddle S4/S5...wait...
-
SSeanRitchie replied to the thread s4 upgrades.Watch my Instagram video for a detailed explanation and showing the differences between Gen 1, 2, and 3. Bottom line is the Gen 3...
-
SSeanRitchie replied to the thread The Transaxle Thread.You can this with an Albins and VW bell housing. That's how Jimco used to build all of their Class 1 cars. But then you're limited to...
-
SSeanRitchie replied to the thread The Transaxle Thread.Sadev makes everything in house other than bearings, seals, and some other common goods. They recently went on a buying spree in Europe...
-
SSeanRitchie replied to the thread The Transaxle Thread.Starting at $50k. It's a very nice trans, Sadev know's how to make a good gearbox, and I have no doubts that they will work well, but...
-
SSeanRitchie replied to the thread The Transaxle Thread.I haven't seen one in person, they were in design phase while I was still at Weddle, but I did see internals in some pictures from Sand...
-
SSeanRitchie replied to the thread The Transaxle Thread.I think the needle bearings are ok to use (I am sure there are a few that would dis-agree with that), but certainly not as good as the...
-
SThanks again @SeanRitchie , got it adjusted and will still (hopefully) make my dunes trip.
-
SSeanRitchie replied to the thread Clutch pedal stop adjustment.There are a lot of factors that go into how far each clutch pedal will need to travel to dis-engage the clutch. Length of pedal Master...
